Skip to content
Boiler Hire CompanyGet a quote
Menu

What do the Pressure Systems Safety Regulations 2000 mean for a steam boiler?

Lagged pipework, gauges and a walkway in an old industrial boiler house

Short answer

The Pressure Systems Safety Regulations 2000 cover any system containing steam, at any pressure.

They require safe operating limits, a written scheme of examination before use, examinations in line with it, instructions for operators, maintenance and records.

Duties fall on the user of an installed system or the owner of a mobile one.

For a hired steam boiler, many of them sit with the hire firm.

On this page
  1. Steam is covered at any pressure
  2. Who the duties fall on
  3. What the regulations require
  4. The written scheme comes first
  5. Safe operating limits and who runs it
  6. A worked example: hiring for a shutdown
  7. Records and the inspector
  8. In short

If your site runs a steam boiler, or you are about to hire one, the Pressure Systems Safety Regulations 2000 (often shortened to PSSR) are the rules that apply to it. This post explains what they ask of you, and how that changes when the boiler is hired rather than owned.

Steam is covered at any pressure

It is easy to assume that a small or low pressure steam boiler sits outside the rules. It doesn’t. The regulations apply to systems containing a “relevant fluid”, and steam counts whatever its pressure.

Other relevant fluids include gases and some liquids held above 0.5 bar above atmospheric pressure, which is why air compressors and receivers come under the same rules. But for a boiler house, the point to hold on to is simple: if it makes steam, PSSR applies.

Who the duties fall on

The regulations put most of the day-to-day duties on one of two people:

  • The user of an installed system, which for a fixed boiler house is normally the employer or business that runs it.
  • The owner of a mobile system, which for a hired steam boiler on a trailer or skid is normally the hire firm.

Designers, manufacturers, suppliers and installers have duties of their own too, covering how the system is built, marked and installed. As the person running the boiler, though, it is the user and owner duties that matter most.

What the regulations require

HSE’s brief guide, INDG261, sets the duties out in plain terms. In outline, the user or owner must make sure the system has the following in place:

Requirement What it means in practice
Safe operating limits Known maximum pressures and temperatures, set out before use
Written scheme of examination A plan for examining the parts where a defect could cause danger
Examinations Carried out by a competent person in line with that scheme
Operating instructions Suitable instructions for anyone who runs the system
Maintenance Kept in good repair so it stays safe
Records The last examination report and other key papers kept

There is a separate rule for modifications and repairs, which must not make the system unsafe. If you change a hired boiler’s pipework, connections or controls, speak to the hire firm first.

The written scheme comes first

The single most important document is the written scheme of examination. The system must not be operated without one, and it has to be drawn up or certified by a competent person. We explain it fully in our post on written schemes.

For a hired mobile unit, ask for the scheme and the latest examination report before the boiler is commissioned. If the hire firm can’t produce both, don’t start it up.

Safe operating limits and who runs it

Every system has limits, mainly pressure and temperature, beyond which it must not be run. The limits should be clear to the people operating it, and the protective devices (safety valves, pressure and level controls) are there to keep it inside them.

Who will actually operate a hired steam boiler on your site? In a lot of cases it is your own staff after a handover from the hire firm. Make sure that handover includes written operating instructions and what to do if a safety valve lifts or a low water alarm sounds.

A worked example: hiring for a shutdown

Say a commercial laundry’s steam boiler is due for a major repair, and it hires a packaged steam unit for four weeks.

Before delivery, the laundry agrees with the hire firm:

  • Paperwork: the written scheme and the latest examination report for the hire unit.
  • Limits: the unit’s safe operating pressure, checked against what the presses and ironers need.
  • Operation: who runs the boiler each shift, with the hire firm’s instructions on site.
  • Boundaries: where the hire firm’s system ends and the laundry’s own steam mains begin.

That last point is often missed. The laundry’s own steam mains and vessels stay under its own scheme as an installed system. The hire firm’s unit is under the hire firm’s scheme as a mobile system. Writing down where the line sits stops either side assuming the other has it covered.

Records and the inspector

Keep the papers together: the written scheme, the last examination report, the operating instructions and any notes of repairs or changes. If an HSE inspector or your insurer visits, those are what they will ask for first.

With hired plant, keep copies of the hire firm’s documents for as long as the unit is on site, and note the dates it arrived and left.

In short

PSSR is less about paperwork for its own sake than about knowing your boiler’s limits and having it examined by someone who can spot trouble. For an owned boiler that is your job. For a hired one, much of it is the hire firm’s, as long as you both know where the line is.

For steam boiler hire with the paperwork in order, see our steam boiler hire page. Need a unit for a shutdown? Tell us the output and pressure below.

Sources

Tell us what needs heating

We find a boiler hire firm that covers your site and give you their name before any of your details go to them. It costs you nothing.

What happens next

  1. We look for a hire firm that covers your postcode and the size of unit you need.
  2. We give you the firm's name first. Your details only go to them if you say yes.
  3. The firm checks the site, confirms the size and sends a written price.

Boiler Hire Company is an independent matching service, not a hire firm. If you hire through the firm we name, they pay us a fee; you pay us nothing.

Step 1 of 3
Where is the building?
Get a quote