Boiler Hire in London
In London the boiler is rarely the hard part. Where it stands, how the hoses reach a basement or roof plant room, and who you ask about the kerb are what take the time. Here is what to sort out first.
33 councils, one question about the kerb
Greater London is split into 32 boroughs and the City of London, and each runs most of the streets in its patch. If the hire unit or the delivery lorry needs to use the road, it is the borough you ask, not the Mayor or a single London office.
The exception is the red routes, the main roads run by Transport for London. On those, TfL's rules apply instead. So the first useful thing to find out is simply: whose road is outside the building?
A building on the boundary of two boroughs may face a road run by the one next door, so check the street rather than the address.
Where will the unit stand?
Outside London, a hire boiler usually goes in a yard or car park next to the plant room. In inner London there often isn't one. These are the usual answers:
- A rear yard or lightwell. Best if the delivery vehicle can reach it, and the most common choice for mansion blocks and older offices.
- On the street. Possible with the highway authority's permission. Expect them to want barriers and a clear footway.
- A car park or service bay. Good for newer offices and schools, as long as the hose run to the plant room is manageable.
- On the roof. Where the plant room is up there already. This nearly always means a crane.
Whichever it is, the spot needs a firm, level standing and room for the flue to discharge safely away from windows and air intakes. The hire firm will look at all of this on its visit.
Basement and roof plant rooms
A lot of London's schools, mansion blocks and Victorian offices keep their boilers in the basement. That is fine for a hire. The unit stays at ground level and the flow and return hoses run down the stairs, through a lightwell or along a service route. Measure that route before you ask; it decides how much hose the firm brings.
Rooftop plant rooms are common on taller blocks. A unit on the roof, or a crane lift to get one into a high courtyard, is a lifting operation under LOLER. It has to be planned by a competent person, and in practice the street below often needs closing for the lift (HSE).

Older buildings lose more heat
If you are sizing a hire unit for a Victorian school or a mansion block with original windows, use the "poor" setting in our sizing calculator. High ceilings mean more volume to heat, and solid walls and single glazing let heat out faster. Better still, read the output off the existing boiler's plate.
Gas, oil or electric in the capital
On tight central sites, gas is often the easiest fuel because there are no deliveries and no tank to find room for. Connection must be by a Gas Safe registered engineer with non-domestic categories. Oil works anywhere a bunded tank fits and a delivery vehicle can reach; in England a tank over 200 litres at a business needs a bund holding at least 110% of its contents (GOV.UK). For a small load or hot water only, an electric unit avoids both questions.
When the heating fails mid-winter
An office or classroom that can't reach a reasonable temperature is an employer's problem. The guidance figure is normally at least 16 °C, or 13 °C for work involving severe physical effort (HSE). Our page on emergency boiler hire covers what the hire firm needs from you on the first call.
Boiler hire in London: questions
Can a hire boiler stand on the street in London?
Sometimes, but it needs permission. Most streets are run by the borough, and red routes by Transport for London. Ask the right one early, because a suspension or licence can take longer to arrange than the boiler itself.
Our plant room is in the basement. Can we still hire?
Usually. The unit stays at ground level, in a yard, lightwell or on the street, and the flow and return hoses run down to the plant room. The hire firm will check the hose route on its visit.
What if the boilers are on the roof?
Then a crane lift is likely, either for a unit on the roof or to keep hose runs short. Lifts are covered by LOLER and must be planned by a competent person (HSE).
Is gas or oil better for a London hire?
Gas avoids fuel deliveries and tank space, which suits tight central sites. Oil works where there is no suitable gas supply near the plant room, but the bunded tank needs room and a delivery vehicle needs access.
Do you cover outer London as well as the centre?
Yes. Send the postcode and we look for a hire firm that covers it, whether that is the City or the edge of Havering or Hillingdon.
Tell us about your London site
We find a boiler hire firm that covers your site and give you their name before any of your details go to them. It costs you nothing.
What happens next
- We look for a hire firm that covers your postcode and the size of unit you need.
- We give you the firm's name first. Your details only go to them if you say yes.
- The firm checks the site, confirms the size and sends a written price.
Boiler Hire Company is an independent matching service, not a hire firm. If you hire through the firm we name, they pay us a fee; you pay us nothing.
Thanks. Your request is with us.
- We get back to you by email or phone, naming a hire firm that covers your site.
- Say yes and we send them your details. Say no and they never see them.
- The firm confirms the unit size and connection on a survey and puts its price in writing. We send no marketing.